As a perfect complement to your Kodiak Trailer Brake System, we offer Dexter Marine / Titan Brand Surge Actuators as the chief authority in the business. This is a Dexter Marine / Titan Model 10 Disc that is rated to 12,500lb of towing capacity and 1,250lbs of tongue weight that uses a 2 5/16" towing ball. When considering carrying capacity and the usage of this model, consider you current carrying capacity. Typically this surge actuator outfits tandem axle trailer with two 5,200lb capacity trailer axles. This would mean that the maximum capacity of the trailer itself would be 10,400lbs. This makes this model ideal for trailers utilizing Kodiak Disc Brake Kits 5200lb 6 Lug, as the capacity of the kits falls under what this Model 10 is rated for.
As far as outfitting this item to your trailer, typically you will be using (2) 1/2 inch Diameter by 4 1/2 inch Long Stainless Steel Bolts to mount to your trailers 3 inch wide tongue. You must have a straight, 3 inch wide tongue to mount this Model 10 actuator. It is not uncommon to need to drill new holes, as different manufacturers use different bolt spaces when the tongue actuators are produced. A Dexter Marine / Titan Surge Brake Actuator works by using the force of the towing vehicle stopping to engage the master cylinder, applying pressure on the brake fluid to flow through the brake lines.
This particular listing is for the Dexter Marine / Titan Model 10 surge Coupler without the Reverse Lockout Solenoid and protector shield. We do offer this model with both of these components in the same category. The Reverse Lockout Solenoid is essential to for your disc brake system to operate properly. If you do not have one you can click on that link to add it to your cart. This devices threads into the rear of the master cylinder. (Your master cylinder is located on the back side of the surge coupler and has a pressure Cap for filling with fluid.) The job of the reverse lockout solenoid is simple. Two wires run from it, one as a ground, and the other connects to your wiring harnesses 5th wire (for 5 Flat connectors). This wire is commonly blue. Under normal operation while driving forward and braking the Reverse Solenoid Valve does nothing, however, once you need to reverse or back into the ramp, this is where the Solenoid Valve becomes crucial. When you put your truck in reverse, a signal is sent to the reverse lockout solenoid (through the 5th wire, which on the truck side connects to your vehicles reverse light) and the device blocks the flow of hydraulic fluid, this allows you to reverse without the surging of the coupler stopping you as you lounge backwards down the ramp. Keep in mind this means as you reverse, your truck is your only source of braking.
When installing a new disc brake system on single or tandem axle disc brakes it is not uncommon to spend a good amount of time priming the lines, and using a good amount of brake fluid. It is important to begin at the furthest away caliper when trying to get the fluid through the lines and our the caliper bleeder.
This is Dexter Marine / Titans Part #4750600 and Includes a Factory Warranty, Installation and Service Manual
When Doing This Project:
After installing the Dexter Marine / Titan Model 6, you will need Heavy Duty Hydraulic Brake Fluid DOT 3 for Trailer Disc Brakes to fill the reservoir as you bleed your trailers disc brake system. Your trailer disc brake system also requires a Boat Trailer Disc Brake Free Backing Reverse Lock Out Solenoid Valve to stop the flow of brake fluid when reversing your vehicle.
